The basic introduction of gear moto
Speed reducer is composed of gear and motor,so we call gear motor.Gear motor usually supplied by complete sets.gear motor can be widely used in steel metallurgical, lifting transportation, car production, electric power, and other industries.The widely used of gear motor is mainly the following reasons:simplified design, save space, prolong service life, reduce noise, improve the torque and load capacity.Reduction ratio is the gear motor input speed and output speed ratio.
Series is the cycle of planetary gear,In general the biggest can reach level 3, efficiency will be reduced.
Gear motor noise arising mainly from the transmission gear friction, vibration and collision.How to effectively reduce noise, make it more environmentally friendly at home and abroad is a key research topic.Many scholars at home and abroad take the variation of gear mesh stiffness as gear dynamic load, vibration and noise.With the changes in form, make its dynamic load and speed to minimize fluctuation, in order to reducing noise.
Geared motor failures and solutions
Produces a variety of gears, gear boxes, geared motors and other products,with a wide range of diverse models that can meet the public demand.Also customized is welcomed.Standard series of gear boxes and geared motors are: powder metallurgy and plastic planetary gear planetary gearbox.However,In according to the customers needs we developed car headlight gearbox and so on .Shznzhen zhaowei can assemble any parts if the customer needed.
The folowing are the problem and the ruled out the method of inclined gear motor and turbinegear motor. If helical gear motor is overheat,the main reasons for this situation are mainly overload or inadequate or excessive lubricating oil.The solution are check the actual load, adjusted to the specified value or greater power gear motor, oil fuel consumption must according to the provisions.Two form noice of helical gear motor: the abnormal of stability and instability of the operating noise.The major reason for the noise is the bearing damage, meshing irregular, oil pollution or lack of oil, etc.The concrete solution: check the amount of oil or quality, found that the oil is pollution or can choose oil.
The ventilation device of Inclined gear motor leakage mainly because oil is too much which caused ventilation device uncorrectly installed.The solution is to fixed oil level and correct installation ventilation device.
The reasons of leakage are sealed damage, can contact with manufacturers to solve the damage problems.
Post time: Jun-18-2021